In this article, we will go over the requirements for sending an All On X Case to us for Design.
You will need to set up your order in 3shape with implant information and unit count included.
Note: Orders will be placed on hold if the information is missing. Designers are unable to make changes to the 3Shape order.
If gingiva is desired:
You must choose 1 of the 2 gingiva options inside the 3Shape Order
- Regular gingiva - a full monolithic hybrid, no cutback included. It will populate a full tissue profile for the design intended to stain in pink.
- Anatomical gingiva - will have a cutback - this is if a customer wants to add porcelain or any other material. It gives the designer the ability to "cutback" the tissue during design so that the finishing technician can stack material and hand build the gingiva in porcelain or gradia.
Note: We must have either the Length of Centrals or an approved wax-up to base the design on.
If you are providing the Length of Centrals:
please type in the instruction box “LOC=”
If you are providing an approved wax-up:
Click on the design guide button and choose one of the following below
We will also need the Material Type specified in the instructions box, i.e. Zirconia, PMMA, Wax, TriLor, or Pekkton. The design is based on the parameters set by the material you choose.
Once all steps have been completed you are ready to send. Just click on the blue paper airplane to send. The turnaround time is 24 Hours!
Please email Customer Support at designservices@3shape.com or Chat with us for any further questions!