In this article, we will go over sending a Crown & Bridge Case to the 3Shape Design Service Platform for design.
Important!
Scan Requirements:
- Upper/Lower scans (Acceptable file extensions- .dcm, .stl, .ply, or .obj)
Optional:
- Bite Scan (If required scans are NOT aligned to the patient's bite, you MUST provide a bite scan.)
- Patient Photos
Limitations:
- Implant-retained restorations are not supported (Any order containing implants must be sent with a complete 3Shape order).
- Bridges are not to exceed a maximum of 1 pontic between 2 preparations (splinted prep crowns are accepted).
Please follow the Steps Below:
1. Click on "Create New Case".
2. Click on the " Crown & Bridge" category and choose your indication.
Important: Crowns and models will be available in the next release on July 1st, 2024. Please note that this might be subject to change.
3. Create your case by filling out the information required.
- Case name, Teeth/Arches, Design Guide Codes, Turnaround time, Additional case comments, case files, and production options.
4. Click on "Review Case Details" double-check the case information and then click on "Create Case".
If you haven't set up your Design Guide Codes yet, please check this article:
Once the case is designed you will get it back for review and all the files will be available for you to download.
Please email Customer Support at designservices@3shape.com or Chat with us for any further questions!